run a sequence with SHS G1888 Agilent and Master GC Dani

You can discuss anything concerning Clarity in this section.
Post Reply
mohharrath
Posts: 2
Joined: Tue Jul 05, 2016 2:22 am

run a sequence with SHS G1888 Agilent and Master GC Dani

Post by mohharrath »

Dear sir,

One of my customer wants run a sequence with SHS G1888 Agilent and Master GC Dani.
I know that Clarity can not control SHS G1888 Agilent .However ,G1888 can
synchronize with master GC by a signal wire (READY):
when the GC is ready the SHS injects the sample and sends a start signal to GC that starts data acquisition in Clarity using the INn starting cable.

what do I have to do? when I want identify a lot of samples and standards.

Any comment is appreciated.

I look forward to hearing from you.

Yours faithfully
Harrath

Lenka Diblikova
DataApex Support
DataApex Support
Posts: 29
Joined: Fri May 20, 2016 10:23 am

Re: run a sequence with SHS G1888 Agilent and Master GC Dani

Post by Lenka Diblikova »

Dear Mohamed,

refer to email sent by Daniel Mentlík July 11th.

Best Regards.
Lenka Diblíková

Post Reply