Page 1 of 1
Two internal standards?
Posted: Thu Jul 15, 2010 3:38 pm
by DavidSwan
I am using a gc method which requires the use of 2 internal standards. Clarity only allows me to select one ISTN peak. Is it possible to define more than one peak as internal standards?
Any help would be much appreciated.
Regards
Re: Two internal standards?
Posted: Mon Jul 19, 2010 6:28 pm
by Jiri Kuntos
Hello David,
Using of two ISTD is not implemented yet, however it is possible to create custom calculations using User Columns, which will calculate the required results. If you will send us the formulas used in your particular application, we can try to propose some suitable solution.
Best Regards
Re: Two internal standards?
Posted: Wed Jul 21, 2010 1:32 pm
by DavidSwan
Jiri Kuntos wrote:Hello David,
Using of two ISTD is not implemented yet, however it is possible to create custom calculations using User Columns, which will calculate the required results. If you will send us the formulas used in your particular application, we can try to propose some suitable solution.
Best Regards
Thanks Jiri.
Is it possible to send you an email or PM?
Thanks
David
Re: Two internal standards?
Posted: Wed Jul 21, 2010 2:59 pm
by Jiri Kuntos
Sure, preferably
support@dataapex.com
Best Regards