Clarity discussion forum

Posted: **Thu Dec 10, 2009 3:25 pm**

I've got a Master GC Dani (1 inj, 1 Det FID) controlled by Clarity 2.8.1.584.
During the "control" phase the baseline on Data Acquisition disappears. Why? Is it correct?
I think it could be useful to be able to monitor the baseline also during the control phase.
I Know that in previous versions I can do it.

Thank you

Michela

Posted: **Tue Dec 15, 2009 5:10 pm**

Dear Michela,

this could be a pending bug in Clarity 2.8.1 we are trying to locate (32048). Please could you check if the signal values are correctly displayed in the status line? This problem is usually solved by redrawing the DataAcquisition window (close and open or resize). Please let me know if this is the case.

Posted: **Fri Dec 18, 2009 1:17 pm**

Dear Ivan,
the signal values in the status line are correctly displayed, but if I close and then I open the Data Acquisition window the problem isn't solved.

Clarity discussion forum

Baseline disappears during the "control" phase

Baseline disappears during the "control" phase

Re: Baseline disappears during the "control" phase

Re: Baseline disappears during the "control" phase