Clarity discussion forum

Hello,

I tried to run a HTA 300L with the Clarity 2.3.0.174 but there is a problem with the sample volume sents to the autosampler.
I make a sequence with 3 runs and 50 µl Inj. Vol. - but an error message occure because the sample volume is to much. I use the AS control menu and click on the From AS button and a sample volume of 500 µl is shown. I tried this with 10 µL in the sequence and the HTA300L injected 100 µL. It looks like the Clarity software is sending an Injection volume with a multiplier of 10.
How can I change that?

Thank you very much in advance.
Best regards,
Hans

Dear Hans

It is a bug, it will be fixed in the next build 2.3.0.183.
I will send you an announcement once it will be available on the web.

Thank you for reporting it.

Petr Kohutek

Hans,

Clarity 2.3.0.183 is available for download from our web.

Petr

PS: It was quite a luck, that we were just preparing new update to be released, normaly it takes longer time to get a fixed feature out (due to the time consuming testing).