Dear Sr.
How can I get in Clarity Software, that the area report be in a big number. In other dataadquisición software (other provider) the peak areas are a big number than in clarity.
Thank in advance for your response.
Jorge Luis Echeverry
Quimitronica Ltda
Diagonal 24 # 43-70
ZIP code 00611
phone:57-1-2448895
fax:57-1-2699999
Bogotá. D.C
COLOMBIA
Email: quimitronica@unete.com
Area report
Area report
Dear Jorge,
there are two possible explanations -
1) the other software uses different units for Area (Clarity uses mV*s).
In Clarity (this option is not supported in Clarity Lite) it is possible to use the user defined columns to get some custom calculations. You can also set the Area column to display more decimals to see numbers with more significant places for low area peaks.
2) the analog input cable is not correctly connected, typically the shield wire (common ground for the plus and minus signal) is not connected. In such case the acquired signal may not correctly reflect the output from the detector.
Please, do not hesitate to contact me for more details
Best regards
Ivan Vins
DataApex, Ltd
Podohradska 1
15500 Praha 5
Czech Republic
Phone +420 251612067
Fax +420 251613507
www.dataapex.com
there are two possible explanations -
1) the other software uses different units for Area (Clarity uses mV*s).
In Clarity (this option is not supported in Clarity Lite) it is possible to use the user defined columns to get some custom calculations. You can also set the Area column to display more decimals to see numbers with more significant places for low area peaks.
2) the analog input cable is not correctly connected, typically the shield wire (common ground for the plus and minus signal) is not connected. In such case the acquired signal may not correctly reflect the output from the detector.
Please, do not hesitate to contact me for more details
Best regards
Ivan Vins
DataApex, Ltd
Podohradska 1
15500 Praha 5
Czech Republic
Phone +420 251612067
Fax +420 251613507
www.dataapex.com
Ivan Vinš
