Re-2: channel operation
Posted: Wed Mar 01, 2006 11:53 am
Good afternoon,
here again the question:
I like dual channel with one time base.
I would like to get indpendent calibration files and calibrations for both channels, because peak one is in channel one and not in channel two. So far fine. Peak three is in channel one and two with different response. that is normally everywhere coming up, where two channel capability is used. If it is not possible to have both calibration files, it is nonsens to use. copy to a different Instrument and so on is nasty and time consuming.
Whow could this easily managed??
Thanks in advance
Kind regards Klaus Jahn
-------- Original Message --------
Subject: RE: channel operation (16-Nov-2005 9:51)
From: kohutek@dataapex.com
To: chroman@chroman.de
> To operate the A/D channels independently you will have to purchase an add-
> on Instrument.
>
> 1 Instrument = 1 time base. This means that you are able to measure a
> chromatogram containing both signals, but you cannot use it for two
> independent chromatographs, where you need to measure independent analysis.
>
> You can contact your dealer and order Add-on Instrument (o/n C55)
>
> Petr Kohutek
> DataApex
>
>
here again the question:
I like dual channel with one time base.
I would like to get indpendent calibration files and calibrations for both channels, because peak one is in channel one and not in channel two. So far fine. Peak three is in channel one and two with different response. that is normally everywhere coming up, where two channel capability is used. If it is not possible to have both calibration files, it is nonsens to use. copy to a different Instrument and so on is nasty and time consuming.
Whow could this easily managed??
Thanks in advance
Kind regards Klaus Jahn
-------- Original Message --------
Subject: RE: channel operation (16-Nov-2005 9:51)
From: kohutek@dataapex.com
To: chroman@chroman.de
> To operate the A/D channels independently you will have to purchase an add-
> on Instrument.
>
> 1 Instrument = 1 time base. This means that you are able to measure a
> chromatogram containing both signals, but you cannot use it for two
> independent chromatographs, where you need to measure independent analysis.
>
> You can contact your dealer and order Add-on Instrument (o/n C55)
>
> Petr Kohutek
> DataApex
>
>