Dear All,

Is it possible to report a warning if , during an analysis run, the input voltage run over the maximum (i.e. 1250 mv)?
Best regards,

Dear Ivan,

The solution 3) is the viable one.
Unfortunately I'm not able to implement it.
I can implement solution 2)as described, but applying it to a peak group shows an error on the "peak type" column.
I'll send you the screenshot by mail.
Can you help?

Best regards

Dear Daniel, The scope is quantify the peaks not in the calibration table by assigning the response factor of a peak whose RF is in the calibration table. Example: In a chromatogram you may have many peaks, not listed in the calibration table, and you want these peaks reported as they were n-hexane ...

Dear all,

Is it possible to enter, instead of the value, a pointer to a known component in the calibration table?
This will allow the automatic recalibration for the unknown peaks as well.

Best regards

Dear all,

Given a calibration file, is it possible to display the chromatogram filenames of the calibration points ?

Many thanks,

It works !!
Thank you

Hi all,

Is it there in Clarity a provision to set up a normalization method using response factors ?

Best regards,

Ade