Hi! We noted that in the Clarity version 3.0.2.244 the temporary files generated with the snapshot are automatically saved and at the end of the analysis the final file doesn't replace the snapshot files. In this case we have got more files for any run. How can we do to avoid the files creation? Are...

Dear Ivan,
the signal values in the status line are correctly displayed, but if I close and then I open the Data Acquisition window the problem isn't solved.

I've got a Master GC Dani (1 inj, 1 Det FID) controlled by Clarity 2.8.1.584. During the "control" phase the baseline on Data Acquisition disappears. Why? Is it correct? I think it could be useful to be able to monitor the baseline also during the control phase. I Know that in previous versions I ca...

Dear Daniel, I send you Clarity.cfg to configure Clarity and 2 images to explain the problem. I configured (Demo mode) the HP 5890 with a single Detector (Demo-1). When I open the instrument and then the Method Setup pages, I note the "Value" cell of the "Global Threshold" haven't the measure unit. ...

Dear Daniel,
we're working with a Clarity full (2.8.1.584) connected to a Dani Master GC (1 injector, 1 detector FID).
We use a LAN communication and we control the GC by a Dani driver, but this problem there is with the Agilent 5890 driver too.

Thank you for your attention

Best regards

Michela

When you open a new or old method in the integration page of the method setup, measurement units are missed, for example mV for Global Threshold.
The measurement units reappear only when you send the method to GC.